Subversion Repositories planix.SVN

#include        "all.h"

char    *errstr9p[MAXERR] =
{
        [Ebadspc]       "attach -- bad specifier",
        [Efid]          "unknown fid",
        [Echar]         "bad character in directory name",
        [Eopen]         "read/write -- on non open fid",
        [Ecount]        "read/write -- count too big",
        [Ealloc]        "phase error -- directory entry not allocated",
        [Eqid]          "phase error -- qid does not match",
        [Eaccess]       "access permission denied",
        [Eentry]        "directory entry not found",
        [Emode]         "open/create -- unknown mode",
        [Edir1]         "walk -- in a non-directory",
        [Edir2]         "create -- in a non-directory",
        [Ephase]        "phase error -- cannot happen",
        [Eexist]        "create/wstat -- file exists",
        [Edot]          "create/wstat -- . and .. illegal names",
        [Eempty]        "remove -- directory not empty",
        [Ebadu]         "attach -- unknown user or failed authentication",
        [Enoattach]     "attach -- system maintenance",
        [Ewstatb]       "wstat -- unknown bits in qid.type/mode",
        [Ewstatd]       "wstat -- attempt to change directory",
        [Ewstatg]       "wstat -- not in group",
        [Ewstatl]       "wstat -- attempt to make length negative",
        [Ewstatm]       "wstat -- attempt to change muid",
        [Ewstato]       "wstat -- not owner or group leader",
        [Ewstatp]       "wstat -- attempt to change qid.path",
        [Ewstatq]       "wstat -- qid.type/dir.mode mismatch",
        [Ewstatu]       "wstat -- not owner",
        [Ewstatv]       "wstat -- attempt to change qid.vers",
        [Ename]         "create/wstat -- bad character in file name",
        [Ewalk]         "walk -- too many (system wide)",
        [Eronly]        "file system read only",
        [Efull]         "file system full",
        [Eoffset]       "read/write -- offset negative",
        [Elocked]       "open/create -- file is locked",
        [Ebroken]       "read/write -- lock is broken",
        [Eauth]         "attach -- authentication failed",
        [Eauth2]        "read/write -- authentication unimplemented",
        [Etoolong]      "name too long",
        [Efidinuse]     "fid in use",
        [Econvert]      "protocol botch",
        [Eversion]      "version conversion",
        [Eauthnone]     "auth -- user 'none' requires no authentication",
        [Eauthdisabled] "auth -- authentication disabled",      /* development */
        [Eauthfile]     "auth -- out of auth files",
        [Eedge]         "at the bleeding edge",         /* development */
};

char*   wormscode[0x80] =
{
        [0x00]  "no sense",
        [0x01]  "invalid command",
        [0x02]  "recovered error",
        [0x03]  "illegal request",
        [0x06]  "unit attention",
        [0x07]  "parity error",
        [0x08]  "message reject error",
        [0x0a]  "copy aborted",
        [0x0b]  "initiator detected error",
        [0x0c]  "select re-select failed",
        [0x0e]  "miscompare",

        [0x10]  "ecc trouble occurred",
        [0x11]  "time out error",
        [0x12]  "controller error",
        [0x13]  "sony i/f II hardware/firmware error",
        [0x14]  "scsi hardware/firmware error",
        [0x15]  "rom version unmatched error",
        [0x16]  "logical block address out of range",

        [0x20]  "command not terminated",
        [0x21]  "drive interface parity error",
        [0x22]  "loading trouble",
        [0x23]  "focus trouble",
        [0x24]  "tracking trouble",
        [0x25]  "spindle trouble",
        [0x26]  "slide trouble",
        [0x27]  "skew trouble",
        [0x28]  "head lead out",
        [0x29]  "write modulation trouble",
        [0x2a]  "under laser power",
        [0x2b]  "over laser power",
        [0x2f]  "drive error",

        [0x30]  "drive power off",
        [0x31]  "no disk in drive",
        [0x32]  "drive not ready",
        [0x38]  "disk already exists in drive",
        [0x39]  "no disk in shelf",
        [0x3a]  "disk already exists in shelf",

        [0x40]  "write warning",
        [0x41]  "write error",
        [0x42]  "disk error",
        [0x43]  "cannot read disk ID",
        [0x44]  "write protect error 1",
        [0x45]  "write protect error 2",
        [0x46]  "disk warning",
        [0x47]  "alternation trouble",

        [0x50]  "specified address not found",
        [0x51]  "address block not found",
        [0x52]  "all address could not be read",
        [0x53]  "data could not be read",
        [0x54]  "uncorrectable read error",
        [0x55]  "tracking error",
        [0x56]  "write servo error",
        [0x57]  "write monitor error",
        [0x58]  "write verify error",

        [0x60]  "no data in specified address",
        [0x61]  "blank check failed",
        [0x62]  "controller diagnostics failed",
        [0x63]  "drive diagnostice failed",
        [0x64]  "diagnostice aborted",
        [0x67]  "juke diagnostice failed",
        [0x68]  "z-axis servo failed",
        [0x69]  "roter servo error",
        [0x6a]  "hook servo error",
        [0x6b]  "I/O self error",
        [0x6c]  "drive 0 error",
        [0x6d]  "drive 1 error",
        [0x6e]  "shelf error",
        [0x6f]  "carrier error",

        [0x70]  "rob made me do it",
        [0x71]  "out of range",
};

char*   tagnames[] =
{
        [Tbuck]         "Tbuck",
        [Tdir]          "Tdir",
        [Tfile]         "Tfile",
        [Tfree]         "Tfree",
        [Tind1]         "Tind1",
        [Tind2]         "Tind2",
#ifndef COMPAT32
        [Tind3]         "Tind3",
        [Tind4]         "Tind4",
        /* add more Tind tags here ... */
#endif
        [Tnone]         "Tnone",
        [Tsuper]        "Tsuper",
        [Tvirgo]        "Tvirgo",
        [Tcache]        "Tcache",
};